Ubidium supports power in and power out using Power over Ethernet (PoE).
Each ethernet port has different capabilities as follows:
| LAN 1 | PoE++ Input, Max 100W supply (71W to device) 802.3af, 802.3at or 802.3bt power source. |
| LAN 2 |
PoE Output, Max 15.4W output, 802.3at standard. Always active when Ubidium is powered on, can run from internal battery power |
| LAN 3 |
PoE+, Max 30W output Only active when connected to external power supply (AC / PoE++ input) |
It is possible to power a secondary Ubidium system using the PoE+ output from LAN 3, this does however require a sufficient external power input to the system. Furthermore, this cannot then be extended further as the power input on the secondary system would be too low.
The Green LED on the left of each PoE port indicates the status of the PoE OUT, the following patterns indicate the function of the port.
| Always Off | PoE disabled or not functioning |
| Blinking |
Searching or ready for input/output |
| Always On | Device detected and powered |
Note that devices using a passive PoE input will not work when connected directly to Ubidium, such devices will require an 802.3af (or equivalent) adapter.